Nexo GEO D Bedienungsanleitung PDF herunterladen (Seite 10)

Page 10/97 GEO D GENERAL SET-UP INSTRUCTIONS

2 GEO D GENERAL SET-UP INSTRUCTIONS

2.1 Speaker Wiring

2.1.1 GEO D10 connectors

GEO D’s are connected to power amplifiers via one AP6 Male Connector (GEOT-612M) on a link cable

that is stowed in the rear vent port. One EP6 Female Chassis (GEOT-613F) on the back connector

panel is used as output to feed the next GEO D.

A wiring diagram is printed on the connection panel located on the back of each cabinet. The EP6 / AP6

connectors are linked in parallel within the enclosures (see the Connections Diagrams section of this

manual).

EP6/AP6 Pin # 1 / 2 3 / 4 5 / 6-

GEO D10

Passive Mode

Rear 8” LF - 16 Ω

1 Negative – 2 Positive

Front 12” LF/MF & 1.4”HF - 16 Ω

3 Negative – 4 Positive

Not Connected

GEO D10

Active Mode

Rear 8” LF - 16 Ω

1 Negative – 2 Positive

Front 12” LF/MF - 16 Ω

3 Negative – 4 Positive

1.4” HF – 16 Ω

5 Negative – 6 Positive

IMPORTANT

NEVER USE a male AP6 connector to feed the signal:

High voltages and currents are delivered from the amplifiers to the GEO D system.

EXPOSURE TO HIGH SOUND

PRESSURE LEVELS MAY CAUSE A

PERMANENT HEARING LOSS.

REFER TO USER MANUAL.

OUT

GEO D10 REAR CONNECTOR PANEL

2.1.2 Configuring GeoD10 for Passive or Active Mode

WARNING

GEO D SERIAL #0100 to #1610 PASSIVE FILTERS DO NOT OPERATE PROPERLY IN ACTIVE

MODE:

IF YOUR GEO D’s ARE WITHIN THESE NUMBERS, PLEASE CONTACT NEXO OR YOUR LOCAL

DISTRIBUTOR SO THAT INSTRUCTIONS AND COMPONENTS ARE SENT TO YOU FOR FILTER

MODIFICATION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 93 94

Keine Kommentare

Nexo GEO D Bedienungsanleitung Seite 10